FF0000 :> Setting CLOACII base address.
   WAIT: **** RV1 calibrate **** Continue?
 

   ?: SET THE 'SCOPE TO RV1.set

   
   Remove The green probe from the 'point to 2 wire' converter
   Locate U11 pin 7
   ?

   0 11


   Now hold the probe on pin 7 and turn the pot with a small screw-driver
   You should see the wave on the screen move. match the rising edges
   to the orange bars.
   ?: Frequency (in white) should read: 11.24 kHz

 
   ?: Now put the probe back in the connector


   RV1 test DONE!