ELogs/MechanicalEngineering

From PBTWiki
Revision as of 15:30, 20 September 2022 by SimonJolly (talk | contribs)
Jump to navigation Jump to search

Electronic Log for Mechanical Engineering

To Do

Proton Therapy

June 2021 - Prepare scintillator sheets to be adhered together using standard primer

November 2021 - Design initial prototype of a new holder that will clamp scintillator sheets together. Will supersede previous adhesive idea

February 2022 - Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped

May 2022- CAD Prototype a sliding system to mount multiple scintillator holders into a case

August 2022 - Created CAD cross hair for Peli Case to be printed. Also created small printed windows to clamp Mylar smooth over the beam entry point.

September 2022 - Machine a patch panel complete with 10 smaller panels that can be swapped between on the main patch panel to allow for various electrical feedthroughs

Radiotherapy

June 2022 - Initiated design of large Peli Case. Received Lab scissor jack used to mount camera.

July 2022 - Created CAD models for internal components including:

- Scintillator holder.

- 2x Side Vice faces.

- 1x Front Vice face.

- Cover for beam entry point.

These were printed soon after.

Beam entry point was cut out of the case, piece was sent for testing with Adam Gibson.

Machined two special 1/4-20 UNC screws for camera mount.

Tapped all holes on Scintillator holder to take m5 nylon screws to allow vice faces to travel.

Completed

2022

Proton Therapy

February 2022 - Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped

May 2022- CAD Prototype a sliding system to mount multiple scintillator holders into a case

August 2022 - Created CAD cross hair for Peli Case to be printed. Also created small printed windows to clamp Mylar smooth over the beam entry point.

September 2022 - Machine a patch panel complete with 10 smaller panels that can be swapped between on the main patch panel to allow for various electrical feedthroughs

2021

  1. June 2021 - Prepare scintillator sheets to be adhered together using standard primer
  2. November 2021 - Design initial prototype of a new holder that will clamp scintillator sheets together. Will supersede previous adhesive idea