ELogs/MechanicalEngineering

From PBTWiki
Revision as of 15:32, 20 September 2022 by SimonJolly (talk | contribs)
Jump to navigation Jump to search

Electronic Log for Mechanical Engineering

To Do

Proton Therapy

June 2021 - Prepare scintillator sheets to be adhered together using standard primer

November 2021 - Design initial prototype of a new holder that will clamp scintillator sheets together. Will supersede previous adhesive idea

February 2022 - Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped

May 2022- CAD Prototype a sliding system to mount multiple scintillator holders into a case

August 2022 - Created CAD cross hair for Peli Case to be printed. Also created small printed windows to clamp Mylar smooth over the beam entry point.

September 2022 - Machine a patch panel complete with 10 smaller panels that can be swapped between on the main patch panel to allow for various electrical feedthroughs

Radiotherapy

June 2022 - Initiated design of large Peli Case. Received Lab scissor jack used to mount camera.

July 2022 - Created CAD models for internal components including:

- Scintillator holder.

- 2x Side Vice faces.

- 1x Front Vice face.

- Cover for beam entry point.

These were printed soon after.

Beam entry point was cut out of the case, piece was sent for testing with Adam Gibson.

Machined two special 1/4-20 UNC screws for camera mount.

Tapped all holes on Scintillator holder to take m5 nylon screws to allow vice faces to travel.

Completed

2022

Proton Therapy

February 2022 - Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped

May 2022- CAD Prototype a sliding system to mount multiple scintillator holders into a case

August 2022 - Created CAD cross hair for Peli Case to be printed. Also created small printed windows to clamp Mylar smooth over the beam entry point.

September 2022 - Machine a patch panel complete with 10 smaller panels that can be swapped between on the main patch panel to allow for various electrical feedthroughs

2021

June
Prepare scintillator sheets to be adhered together using standard primer
November
Design initial prototype of a new holder that will clamp scintillator sheets together. Will supersede previous adhesive idea