ELogs/MechanicalEngineering

From PBTWiki
Revision as of 17:20, 20 September 2022 by SimonJolly (talk | contribs)
Jump to navigation Jump to search

Electronic Log for Mechanical Engineering

To Do

Proton Therapy

Medium-sized Peli case

  • Due date: 20th October
  • Currently in Simon's office next to radiator.
  1. Install Thorlabs optical breadboard in base of case.
  2. Cut out window at each end of case for mylar window installation.
    • Max width 20cm.
    • Bottom of window level with optical breadboard.
    • Top of window flush with handle support struts.
  3. Cut out 2 windows for 2-gang patch panels, 1 per side.
  4. Cut out 2 windows for 1-gang patch panels, 1 per end.
  5. 3D print frames for mylar windows

Completed

2022

September
Machine a patch panel complete with 10 smaller panels that can be swapped between on the main patch panel to allow for various electrical feedthroughs
August
Created CAD cross hair for Peli Case to be printed. Also created small printed windows to clamp Mylar smooth over the beam entry point.
July
Created CAD models for internal components including:
  • Scintillator holder.
  • 2x Side Vice faces.
  • 1x Front Vice face.
  • Cover for beam entry point.
These were printed soon after.
Beam entry point was cut out of the case, piece was sent for testing with Adam Gibson.
Machined two special 1/4-20 UNC screws for camera mount.
Tapped all holes on Scintillator holder to take m5 nylon screws to allow vice faces to travel.
June
Initiated design of large Peli Case. Received Lab scissor jack used to mount camera.
May
CAD Prototype a sliding system to mount multiple scintillator holders into a case
February
Create CAD model for small Peli Case so ideas on how to install the holder into the case can be prototyped

2021

November
Design initial prototype of a new holder that will clamp scintillator sheets together. Will supersede previous adhesive idea
June
Prepare scintillator sheets to be adhered together using standard primer