Proton Calorimetry/Meetings/2022/09/07: Difference between revisions

From PBTWiki
Jump to navigation Jump to search
No edit summary
No edit summary
Line 7: Line 7:
=== [[ELogs/SaadShaikh|Saad Shaikh]] ===
=== [[ELogs/SaadShaikh|Saad Shaikh]] ===
*Assembled prototypes and performed [https://www.hep.ucl.ac.uk/pbt/wiki/Proton_Calorimetry/Experimental_Runs/2022/Jun16 beam test at UCLH] on September 1st.
*Assembled prototypes and performed [https://www.hep.ucl.ac.uk/pbt/wiki/Proton_Calorimetry/Experimental_Runs/2022/Jun16 beam test at UCLH] on September 1st.
**Discussed results in this presentation.
**Discussed results in [http://www.hep.ucl.ac.uk/pbt/wikiData/presentations/2022/SS220907_UCLH.pptx this presentation].
*Geant4 simulation work:
*Geant4 simulation work:
**Found that fixing Birks' constant improved fit with simulated PDL curves – went back to Laurent's simulated data and found that fits fail unless Birks' constant is fixed.
**Found that fixing Birks' constant improved fit with simulated PDL curves – went back to Laurent's simulated data and found that fits fail unless Birks' constant is fixed.

Revision as of 15:25, 8 September 2022

Minutes for UCL Proton Calorimetry Meetings, 7th September

Present

Saad Shaikh, Sonia Escribano, Simon Jolly

Saad Shaikh

  • Assembled prototypes and performed beam test at UCLH on September 1st.
  • Geant4 simulation work:
    • Found that fixing Birks' constant improved fit with simulated PDL curves – went back to Laurent's simulated data and found that fits fail unless Birks' constant is fixed.
    • Preliminary tests of binned fitting rate using simulated data: 3.55 Hz with 10 data points; 2.70 Hz with 36 data points and 0.64 Hz with 128 data points.
    • Next step is to check photon propagation to edges of scintillator and investigate stepping observed with high resolution PDD.
  • Set up template for research paper on Overleaf using Quenched Bragg paper.
  • Matt Warren has fixed USB104 DAQ problems, will acquire code and implement his changes.
    • Will also test set up with USB104 and GUI on Raspberry Pi.

Sonia Escribano